Outline for the 2008 General Class License Course

Last July, the National Council of Volunteer Examiner Coordinators (NCVEC) released a new question pool for General Class license examinations. Shortly after, the ARRL (and others) came out with a new license manual. That meant, of course, that I had to come up with a new outline for my General Class license course.

The new outline is below. One thing I notice about the new manual is that it seems to be better organized than the previous one. I would have organized Chapter 4: Components and Circuits a bit differently, but overall, I like this manual better than the old one.

WEEK 1
Introduction

DC Circuits - Section 4.1

  • voltage
  • current
  • resistance
  • Ohm’s Law

AC Waveforms - Section 4.1

  • peak voltage
  • peak-to-peak voltage
  • RMS voltage
  • wavelength
  • frequency

Power - Section 4.2

  • deciBels
  • peak envelope power (PEP)

WEEK 2
Circuit Components - Section 4.3

  • circuit parameters
  • resistors
  • inductors
  • capacitors
  • transformers
  • vacuum tubes

Series and Parallel Circuits - Section 4.3

  • Kirchoff’s Laws
  • capacitive reactance
  • inductive reactance

Impedance - Section 4.4

  • resonance
  • impedance matching

WEEK 3
Solid-State Components - Section 4.5

  • diodes
  • transistors
  • integrated circuits
  • microprocessors

Practical Circuits - Section 4.6

  • power supply circuits
  • batteries, alternative power
  • connectors

Test Equipment - Section 4.7

WEEK 4
Amplitude Modulaton, Angle Modulation - Section 5.1
Digital Modulation - Section 5.2
Radio Building Blocks - Section 5.3

WEEK 5
Transmitters - Section 5.4
Receivers - Section 5.6
The HF Station - Section 5.7

WEEK 6
Antenna Basics - Section 6.1
Dipoles, Ground Planes, and Random Wire Antennas - Section 6.2
Yagi Antennas - Section 6.3
Loop Antennas - Section 6.4
Specialized Antennas - Section 6.5
Feedlines - Section 6.6

  • standing wave ratio (SWR)
  • impedance matching
  • losses

The Ionosphere - Section 7.1
The Sun - Section 7.2
Scatter Modes - Section 7.3

WEEK 7
Basic Operating Procedures- Section 2.1
Digital Modes - Section 2.2
Nets and Emergency Operation - Section 2.3
Regulatory Bodies - Section 3.1
Licensing Rules - Section 3.2
Control Operators and Their Responsibilities - Section 3.3
Technical Rules and Standards - Section 3.4

WEEK 8
Electrical Safety - Section 8.1
RF Exposure - Section 8.2
Outdoor Safety - Section 8.3
Exam Review

I’ll be adding more detail to the outline as I go along.

Leave a Reply »»

CAPTCHA image